This blog had an unintentional break in transmission, largely due to the lack of writing material. I have been knitting, but they are projects that I can’t quite blog about just yet. In the meantime, I thought I’d break up the radio silence with a story about my next (bloggable) project.

This project was started in 2005, after finding the pattern in a local op shop. The title of the pattern book is Suave Sweaters. Unfortunately I seem to have misplaced the pattern book, but if you think along the lines of ‘Men’s jumpers from the 70s, vacuumed sealed onto the model’, you’re in the ball park. Within this gem of a book, was a nice diagonal rib jumper that I thought would look good on Matt, in a non vacuum sealed form.

So off I went, and in my usual slow and steady pace, finished all parts of the jumper by 2006 (admittedly it was a 5ply pattern, using 3mm needles). As I was seaming it up, I got Matt to try it on, and it was HUGE. The sleeves were more like drop, rather than set in, sleeves, and you could reasonably fit 1.5 Matts in the body.

Down, but not out, I frogged it all and started again. The second time round it took me a bit longer due to a slight lack of interest and the gauge conversions to get the parts right. Being slightly wiser, the parts were measured against Matt at regular intervals and everything seemed to be going swimmingly. Until seaming.

I had managed to screw up the conversion at the armscye, so the sleeve caps were waaaaaay too small. Slightly more forlorn than the first time, the suave sweater sat in my pile of ‘to do’ knits for another year or so. Now I think I’m ready to tackle it again.

I have a handy dandy calculator in hand and a little bit more knitting experience under my belt. Hopefully it’ll be third time lucky.

Does this make me a process knitter? Or just stubborn (or foolish)?